Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Session 5 : Orthographic Drawing II –
Production of a mechanical drawing
How to draw a
multiview projection
of a wall bracket???
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Multiview projection: 3rd angle
1
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
How to create a drawing
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Steps to create a drawing
1. Sketch the multiview from the isometric
view and locate the views on the drawing
sheet
2. Draw a light construction of view
Starting from Front view Æ Top viewÆ
Side view
3. Line in progressively working down and
across the page by using a set square.
4. Dimension and insert subtitle & notes
2
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Typical layout of a drawing sheet
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Dimension of working space
3
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Step 1 Locate positions of views
10 mm.
10 mm.
• Assume a paper size of 594mm x 385mm (non-standard size)
• A 10-mm border width is assigned for A2, A3, and A4 papers.
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Step 2a Draw a light construction of Front view
4
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Step 2b Project from Front view to Top view
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Step 2c Project from Front & Top views to Side view
45o
5
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Step 3 Line in progressively using a set square
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Step 4 Dimension and insert subtitle
6
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Methods of projection between views
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Use of projection and dimension lines
7
Faculty of Engineering, TU
ME 111 Engineering Graphics
TEP & TEPE: International Programmes of Engineering
Exercise: a steel wall bracket
1) Calculate the
position of the
multiview
projection on
A2 paper
(594 x 420 mm)
2) Sketch the
multiview
projection on
A4 paper
(not to scale)
8